Page 2 – Genset / Mounting / Air / Lube
Marine Gen Drive Engine Application Review Form – August 2025
Only the first section starts open. All other sections are collapsed by default.
New Genset Information
Collapse
Genset Manufacturer/OEM
Generator Make/Model
S/N
kWe
Frequency
Populated from Page 1 engine frequency.
Amp Rating
kVA
Efficiency %
Parallel
Yes
No
Paralleling Method
Auto
Manual
Either
Controller Make/Model
Throttle Type
Generator Mass Elastic Data Included With Report
Yes
No
Powered Components, including alternator(s) (AG31)
Expand
Powered Components Installed?
Yes
No
Select No when no additional driven components are installed.
Add each driven component separately so make/model, cranking engagement, power requirement, drive type, and use are preserved in the export.
Add Component
Factory Installed Alternator
Yes
No
Alternator Voltage
Alternator Current
Genset Mounting (AG27 / AG23.5)
Expand
Engine Installation Angle °
Installation Angle Direction
Nose Up
Nose Down
Dipstick Re-marked
Yes
No
Type of Mounting
Solid
Isolated
# Points
Engine Lift Straps Removed?
Yes
Comments
Engine lift straps must be removed after engine installation.
Air Intake / Ventilation (AG03)
Expand
Engine Within Enclosure or Engine Room
Yes
No
Air Filter
Standard
Other
Air Filter Other
Total Engine Room Intake Vent Area
in²
cm²
Intake Fan
Yes
No
Intake Fan Rated Flow
Total Engine Room Exhaust Vent Area
in²
cm²
Exhaust Fan
Yes
No
Exhaust Fan Rated Flow
Remote Mounted Air Filter
Yes
No
Remote Air Filter Diameter
in
cm
Remote Air Filter Pipe Length
ft
m
Number of Elbows: 45°
Number of Elbows: 90°
Verification Method
Full Load Measurement
Calculated
Vented Air Required (Calculated)
CFM
m³/min
Minimum Inlet and Exhaust Vent Sizing
in²
m²
When using the calculated vented area values, upload the ventilation air calculation Excel file with the sea trial.
Comments
Lube Oil System (AG23.5)
Expand
Crankcase Ventilation
Closed System
Open System
Duplex Oil Filter
Yes
No
Remote Mounted Oil Filter
Yes
No
Comments
Powered Component
Remove
Make and Model (JD Part Number if Applicable)
Engaged While Cranking
Yes
No
Max Power Required hp
Drive Type: Aux / Pulley / Crank / etc.
Used For